Under some specific spray painting area such as polyurea and glue application, the liquid viscocity is quite high. The traditional pneumatic paint pump is not workable, especially when the paint or glue will be a problem of cleaning. Thus for such liquid spraying, we normally suggest pressurized pot or airless pump. Here we will introduce one advance choice for glue spraying – Timmer glue pump.
Timmer glue pump is a piston pump with inside electric heater and control. liquid glue can be steadily supplied with digital displaying on control panel. As long as compressed air is powered in, glue can be delivered via pipelines. Fluid rate can be easily adjusted by valve. This Timmer-PTI-D2 glue pump specification as follows.
General properties
| Drive | Pneumatic – self suction |
| Height capacity | ≈2mWS (20 °C) |
| Ratio | 3.8 : 1 |
| Maximum fluid(water) | 33cm³(4 l/min / 240 l/h under 2 Hz speed) |
| Liquid temperature | Maximum 50℃ – electric adjustable |
| Liquid viscosity | Maximum 100.000 mPa s |
| Low pulse | Liquid fluctuation between intake and outtake |
| Intake connection | Tube(420 mm) |
| Pressure connection | Metal connector, 19 mm |
| Weight | 6,9 kg |
| Speed | 2 Hz (maximum) |
Eelctric properties – (with heater device)
| Electricity | 200 – 240V, 50/60 Hz |
| Input power | 950 W (under maximum heating) |
| Protective cable | 2 m rubber cable |
| Temperature | Electric |
| Temperature valve | RT~ +50 °C |
| Temperature controller | Panel type button control/ Timmer program |
| Protection grade | IP66 (dust and water proof) |
| Remote control | Available |
Pneumatic properties
| Compressed air connection | Air connector 7,2 NW |
| Working pressure | 3 – 6 bar |
| Air consumption | 170 l/min (maximum usage) |
| Drive (with heater) | Two five-way valve |
| Drive (without heater) | Pneumatic automatic valve |
